![]() On my Logitech K380 Keyboard I pressed Fn + P to get it in an Android/PC type of configuration. These are the steps I followed, in case helps:Ĭonnected over SSH to the MiSTer and run bluetoothctl, then did the following: I do not need to pair my input devices everytime I reboot the MiSTer. The configuration remains after reboots, power off / power on. I'm just using the standard bluetoothctl. Instead of using the provided bluetooth_pair.sh script and all the other scripts that are called from this one. Is there a list of known working bluetooth keyboards that will reconnect automatically or is it pot-luck? Not sure if this is a software issue or a HW issue?Īlright, I managed to get it working. I also tried to use an Apple A1314 wireless keyboard but that has a similar issue, where it will not connect automatically once paired. I have a Logitech K400 and that works fine without needing to pair, but then it has it's own USB receiver. ![]() I've also unplugged every other USB device (except a controller needed to control the menu) I've tried all the USB sockets in the hub with the same results. Keyboard used: Logitech K380 bluetooth keyboardīluetooth dongle(s): Belkin F8T065 and Aukru CSR 4.0 (CSR8510 based) If I run the bluetooth pairing script again from the scripts menu it will start working again. After that pairing message the keyboard does not pair and fails to work.
0 Comments
Leave a Reply. |